SIG Blomax 4 के लिए प्रतिस्थापन लैंप

Wed, 29 Jul 2026 12:13:37 +0800

अपने SIG Blomax 4 हीटिंग सिस्टम को सही तरीके से सेट करना

यदि आपने KHS या SIG Blomax 4 का उपयोग किया है, तो आपको इसकी असमान गर्मी-वितरण प्रणाली की समस्या का अनुभव हुआ ही होगा। प्रीफॉर्म का एक हिस्सा बिल्कुल सही तरीके से फैलता है, जबकि दूसरा हिस्सा बहुत मोटा ही रह जाता है। यह बहुत ही परेशान करने वाली बात है… आपको सही गुणवत्ता वाले उत्पाद प्राप्त करने हेतु मशीन से लगातार संघर्ष करना पड़ता है।

साइडेल एसबीओ 4 इन्फ्रारेड लैंप

Mon, 01 Jun 2026 23:14:26 +0800

On a blow molding line, uneven preform heating isn’t just a speed killer. It shows up as wall thickness variation, crystallization, and scrap that piles up fast. When the heating tunnel can’t hold temperature across cavities, you end up chasing setpoints instead of running stable cycles. The Sidel SBO 4 infrared lamp is built to get you back to the OEM heating profile—without guesswork. What matters, technically We built the SBO 4 as a direct-fit infrared emitter for Sidel SBO blow molders, with 1:1 parameter matching to the machine’s heating tunnel interface. The lamp uses short-wave infrared in a quartz envelope, so it responds quickly and holds tight control during preform heating. It’s rated for standard line voltages and uses the same connector and mounting as the original, so you can swap it in without modifying brackets or rewiring the heater block. In practice, that means faster warm-up, repeatable temperature across cavities, and less drift during long runs. Here’s why it works in stretch blow molding: the heating phase sets everything that follows—cycle speed, bottle weight, and the reasons you get rejects. The SBO 4 restores the energy density and dwell timing the machine was designed for, so the heating curve stays consistent even when you push higher line speeds. Operators see fewer alarms tied to temperature deviation, and maintenance gets predictable lamp life, which cuts unplanned changeovers. The payoff is stable output, less scrap, and less downtime spent tuning the tunnel. Installation is straightforward, but keep the heating window clean. Dust on reflectors and quartz surfaces robs output and can create hot/cold spots. Match the lamp to the exact wattage and length specified for your SBO model; mismatched emitters can cause over- or under-heating that shows up as quality issues even when the machine looks fine on the surface. Plan replacement around preventive maintenance, not failure, and you keep the line running at the rate it was built to deliver.

4 on Eco Infrared Heating

SIG Blomax 4 के लिए प्रतिस्थापन लैंप

अपने SIG Blomax 4 हीटिंग सिस्टम को सही तरीके से सेट करना

साइडेल एसबीओ 4 इन्फ्रारेड लैंप